- KOSKETUS NÄYTÖT
- PANELIT
- SENSORIT
- KELLO OHJAIMET
- YHDYSLAITTEET
- OHJELMAT
 |
12V DC 50mA, supplied from DyNet network 8 independent, individually controllable outputs 4 x 3.5mm stereo jack connector, accepts stereo & mono plugs 1 x IR input, used for learning & saving unknown IR codes |
 |
DDMIDC8 - Dry Contact/Voltage Input Interface
8 x Opto Isolated inputs, each configurable to Dry Contact or 0-24V AC/DC inputs4 x 0-10V DC analogue non-isolated inputs LED status indicators for each opto isolated input Programmable logic controller |
 |
DDNG485 - Network Gateway
Powered from the network, no mains supply required 2 x RS485 DyNet serial ports Optical Isolation between ports Programmable message filtering Programmable logic controller |
 |
DDNI485 - Network Isolator
12DC 10mA from the DyNet network, fed via Port 1 2 x RS485 DyNet/DyNet II serial ports 3.75KV RMS optical isolation between ports |
 |
DDNI-LON - DyNet to LON Interface
DyNet to LON interface 1 x RS485 DyNet Serial Port 1 x TP/FTT10A twisted pair LONWorks port Supports 63 SNVTs |
 |
DMNG100BT - 10/100Base T Ethernet Interface
15V DC supplied by the DyNet network , DyNet to Ethernet Gateway 1 x RS485 DyNet serial port , 1 x 10/100BaseT Ethernet port Supports TCP/IP protocol, with static or DHCP assigned IP addressing Integral webserver |
 |
DNG100BT - 10/100Base T Ethernet Interface
230V ±14% 50/60Hz Single Phase at <0.1ADyNet the Ethernet Gateway 1 x RS485 DyNet serial port 1 x 10/100BaseT Ethernet port Supports TCP/IP protocol, with static or DHCP assigned IP addressing |
 |
DNG232 - RS232 Gateway
DyNet to RS232 GatewayPre-programmed “Plain English” text interpreter mode Pre programmed Remote Access Modem mode RS232 Baud rate: 600 - 460800 |
 |
DNG485 - Network Gateway
230V ±14% 50/60Hz Single Phase at <0.1A2 x RS485 DyNet serial ports 3.75KV RMS Optical Isolation between ports, Packet filtering DyNet to DyNet II translation, Programmable logic controller DMX512 Receive: 64 channels, DMX512 Transmit: 64 channels |
 |
DTK502 - Dry Contact Inputs
Designed to fit into third party devices to allow operation on a DyNet network. 4 dry contact inputs Powered from the DyNet network Small enough to fit into 3rd party PIR motion sensors Firmware supports special "motion detector" mode |
 |
DTK932V7 - Network Bridge
230V ±14% 50/60Hz Single Phase at 0.25A 2 x RS485 serial ports, supports DyNet & DMX512 TX Programmable message filtering , Programmable logic controller DMX512 Transmit - 512 Channels Memory: 8Kb EEPROM, 512Kb DRAM, 1024Kb FLASH |
